C888EG+7-K9
How to check the local loop status on the Cisco Router C888EG+7-K9:
the local loop which is connected to this router is connected with EFM technology
the below output shows that there is just one local loop and its data rate ( BW ) is 2752 Kbps and it can carry until 5696 but is configured from DSLAM to carry just 2752 Kbps
Router#sh controllers shDSL detailed
Controller SHDSL 0 is UP
Capabilities: EFM, 2-wire, Annex A, B, F & G, CPE termination
cdb=0x87223154, ds=0x872232A4
Vendor: Conexant, Chipset: CX98124
Firmware file: System, Firmware version: 115..1..1
Number of pairs: 1, number of groups configured: 1
Group info:
Type: 2-wire g.shdsl, status: Up
Interface: Ethernet0, hwidb: 0x872448CC
Configured/active num links: 1/1, bit map: 0x1/0x1
Line termination: CPE, Annex: A-F
Line coding: AUTO-TCPAM group data rate is 2752 kbps
Loopback type: None
Dying Gasp: Present
Mode: Fixed
SHDSL wire-pair (0) is in DSL UP state
LOSW Defect alarm: none
CRC per second alarm: none
Termination: CPE, Line mode: 2-wire, Annex: F
Line coding: 16-TCPAM,
Configured data rate/actual data rate: 5696/2752
Modem status: GTI_DATA_OP
Last Failed State: None
Framer Sync Status: 1
Loop Attenuation: 20 dB
Transmit Power: 13.5 dB
SNR margin: 18 dB
Current 15 minute statistics (Time elapased 243 seconds)
ES:0, SES:0, CRC:0, LOSW:0, UAS:0
Previous 15 minute statistics
ES:0, SES:0, CRC:0, LOSW:0, UAS:0
Current 24 hr statistics
ES:0, SES:0, CRC:0, LOSW:0, UAS:0
Previous 24 hr statistics
ES:0, SES:0, CRC:0, LOSW:0, UAS:0
EFM stats:
Receive stats:
Pkts:16822949
CRC:0
Transmit stats:
Pkts:12972292
xMII stats
Tx Stats:
Bytes: 1488733405, Pkts: 18463943
Pause frames: 0
FCS Err: 0, Undersize Pkt Err: 0, Oversize Pkt Err: 0
Rx Stats:
Bytes: 1863033216, Pkts: 12972292
Pause frames: 0
FCS Err: 0, Undersize Pkt Err: 0, Oversize Pkt Err: 0
Alignment Err: 0, Framelength Err: 0
Fragment Err: 0, Drops: 0
No comments:
Post a Comment